Move to main text

LED lighting

Proposal for energy saving

Significant reduction in electricity charges!

Replacing fluorescent lights with LEDs can reduce your electricity bill by about 60%.
The earlier the introduction, the greater the saving effect.

Work efficiency is improved by the LED with dimming function!

The brightness and color of the CV21 LED can be adjusted according to the work environment.
Customers have commented that the introduction of LEDs has made it easier to handle warehouse cargo and office work.

LED with motion sensor saves even more!

It detects a person and turns on automatically, and turns off automatically when there are no more people.
Recommended for corridors, etc.

Save a lot of initial costs!

Since it can be attached to existing fluorescent lighting fixtures with simple electrical work, installation costs can be reduced.
In addition, if you use installments and leasing, you can save a lot of initial investment. Please contact us.
LED and fluorescent cost simulation

Product Introduction

Benefits of introducing LED lighting

  • Power consumption can be significantly reduced
    In general, the power consumption of LED lighting is reduced by 40-60% compared to fluorescent lamps. This also contributes significantly to the reduction of CO2 and plays a major role in preventing global warming.

  • Eco-friendly lighting that does not use mercury
    LED lighting does not use mercury contained in fluorescent lamps, so it can be said to be environmentally friendly lighting. Also, since the arc tube is made of polycarbonate, the glass will not scatter even if it breaks.

  • Long life of 40,000 hours
    It is said that the expected life of fluorescent lamps is about 6,000 to 12,000 hours, but LED lighting is characterized by a much longer expected life of 4 hours. This greatly reduces the frequency of lighting replacement.

  • Less fever
    LED lighting is a light source that does not generate much heat, and compared to lighting such as fluorescent lamps, it can be expected to suppress the rise in indoor temperature and improve the efficiency of air conditioning.

  • There is little ultraviolet light
    Since the light from LED lighting contains less ultraviolet rays that cause sunburn, it is less likely to fade or deteriorate even when irradiated to works of art, and it is also possible to prevent insects that are attracted to the ultraviolet rays from flying in.

  • No ballast required
    Since LED lighting uses a power supply dedicated to LEDs, a ballast for fluorescent lamps is not required to light the LEDs. In addition, ballasts that have exceeded their lifespan may increase power consumption or cause an accident.

Features of straight tube LED lighting / CVL series

Industry-leading high efficiency! Power consumption14.8W, Bright enough
If you replace the 40-inch fluorescent lamp (40W) with our LED (14.8W),About 60%Reduces power consumption.
Brightness is equivalent to 40 type fluorescent lamp2,149lm(Lumen).

The initial cost can be reducedNo need to replace equipmentType
Since the CVL series is a G13 base type, it can be attached to the fluorescent lamp equipment you are using with simple construction. (If the device is very painful, it may not be possible to install it.)

Long life40,000 hours(Expected life of light source), and more secureProduct warranty 3 years
It lasts about 10,000 times longer than the expected life of fluorescent lamps (about 4 hours). The frequency of lamp replacement is greatly reduced. For general usage time, the payback period is less than 3 years. You can rest assured with a 3-year product warranty.
 
Why don't you save electricity and power cost for eco2 with LED lighting of CVL series?

Reliable quality control system

Quality Control Manager Tsuneki Kitamori
All LED lighting "CLV series" are inspected at the CV21 Kyoto factory. A serial number can be printed on the accepted products for tracking management.
We guarantee the quality for 3 years, so you can use it with confidence.
Inspection contents
Inspection report and inspection scenery

Characteristic lineup of CVL series

Straight tube type LED popular type

  • LED lamps can be installed using existing lighting fixtures.
    With a G13 base and a slim shape with a tube diameter of 30 mm, not only general fluorescent lamps (FL, FLR) but also Hf fluorescent lamps can be replaced with LEDs without changing the equipment you are using.
    *When installing this LED lamp on an existing fixture, it is necessary to investigate the condition of the existing fixture in advance.
  • Power consumption can be significantly reduced by about 40% of fluorescent lamps.
Model
Input voltage
(V)
power consumption
(IN)
Total luminous flux
(Lm)
Luminous efficiency
(Lm / W)
Color temperature
(K)
Color rendering
(Ra)
life
(time)
CVL20T110
Equivalent to 20 type
AC90-240
9.6
1,092
114
5,000
82.0
40,000
CVL40T120
Equivalent to 40 type
AC90-240
17.8
2,136
120
5,000
82.0
40,000
CVL40T45A50
Equivalent to 40 type
AC90-240
14.8
2,149
145
5,000
83.7
40,000

Straight tube type LED 3-stage dimming type

  • Dimming can be done on the spot even after replacement according to your needs.
    For example, you can reduce the brightness near the window to save power, and increase the brightness in a room without windows. By switching the switch according to the needs of the place, you can adjust the light in 3 steps on the spot.
Model
Input voltage
(V)
power consumption
(IN)
Total luminous flux
(Lm)
Luminous efficiency
(Lm / W)
Color temperature
(K)
Color rendering
(Ra)
life
(time)
Dimming
(※ 1)
CVL40T145S3
Equivalent to 40 type
AC90
~240
18.8
2,632
140
5,000
82.0
40,000
H
14.8
2,146
145
M
11.8
1,711
L
CVL40T175S3
Equivalent to 40 type
AC90
~240
15.5
2,635
170
5,000
82.0
40,000
H
12.3
2,152
175
M
9.8
1,722
L
CVL110T145S3
Equivalent to 110 type
AC90
~240
49.0
6,860
140
5,000
82.0
40,000
H
39.0
5,655
145
M
29.0
4,205
L
*1 H: High illuminance mode, M: Standard lighting mode, L: Low power consumption lighting mode

Straight tube type LED color temperature / luminous flux switching type

  • Offices and stores will change. The color tone and amount of light of the lamp can be freely adjusted!
    If you use the dedicated remote control, you can adjust the color tone of the lamp from daylight color to light bulb color according to your preference, and you can freely switch the light intensity (total luminous flux) between 2,700 lm and 550 lm.
    *Remote control is sold separately.
  • If you set the channel, you can adjust multiple channels at once.
    If you use the channel setting function of the dedicated remote controller, you can divide multiple straight tube LEDs into up to 4 groups and register them in groups, and you can adjust the color tone and light intensity as a whole or in groups.
Model
Input voltage
(V)
power consumption
(IN)
Total luminous flux
(Lm)
Luminous efficiency
(Lm / W)
Color temperature
(K)
life
(time)
CVL40TUSP
Equivalent to 40 type
AC90-240
22.0
2,700
122
2,700-6,500
40,000
19.5
2,383
122
2,700-6,500
17.0
2,077
122
2,700-6,500
14.5
1,772
122
2,700-6,500
12.0
1,466
122
2,700-6,500
9.5
1,160
122
2,700-6,500
7.0
855
122
2,700-6,500
4.5
550
122
2,700-6,500
*2: The total luminous flux is a guide. It depends on the color temperature.

Straight tube type LED with motion sensor

  • The sensor detects the movement of a person and automatically turns it on and off.
    When the motion sensor built into the LED lamp detects a person within the sensing range (height 3m, diameter 5m), the lamp automatically lights up. Also, if there is no person within the sensing range after the set lighting time has passed, the lamp will automatically turn off.
  • With the changeover switch, you can select lighting time and complete extinguishing or 10% luminous flux
Straight tube type LED motion sensor type / installation example
Corridor
backyard
Bathroom
Model
Input voltage
(V)
power consumption
(IN)
Total luminous flux
(Lm)
Luminous efficiency
(Lm / W)
Color temperature
(K)
Color rendering
(Ra)
life
(time)
CVL20T100J4
Equivalent to 20 type
AC90-240
10.0
1,000
100
5,000
82.0
40,000
CVL40T120J4
Equivalent to 40 type
AC90-240
17.8
2,136
120
5,000
82.0
40,000

LED base light GB1 series

  • Slim & thin design
    A slim, industry-leading thin (38mm) design base light. Although the light source, power supply, and mounting part are integrated, the weight of the main body is suppressed to 1 kg or less (GB1 series), and it can be handled easily.

  • Low frequency noise
    Achieves low noise and high efficiency. All models of the GB1 series have cleared the CISPR15 standard, so you can use it in data centers with confidence.

  • Long life 60,000 hours
    The long-life design makes it ideal for places where maintenance is difficult.
    * Expected life of the light source when the average ambient temperature is 30 ° C

  • Easy to install
    A slide cover mechanism is used for the mounting part.The main body can be held with one hand and can be installed by one person.
    *Electrician qualification is required.
GB-1 series / outline drawing
Model
Input voltage
(V)
power consumption
(IN)
Total luminous flux
(Lm)
Luminous efficiency
(Lm / W)
Color temperature
(K)
Color rendering
(Ra)
life
(time)
GB100258NSA
Equivalent to 40 type 1 light
AC100
~242
18.8
2,150
114
5,000
85.0
60,000
GB101756NSA
Equivalent to 40 type 2 light
AC100
~242
39.0
4,000
102
5,000
85.0
60,000
GB102158NSA
Equivalent to 40 type 2 light
AC100
~242
40.0
5,500
137
5,000
85.0
60,000
GB101358NSA
Equivalent to 40 type 2 light
AC100
~242
34.2
5,250
153
5,000
85.0
60,000
GB110258NSA
Equivalent to 110 type 1 light
AC100
~242
40.3
5,400
134
5,000
85.0
60,000
GB110758NSA
Equivalent to 110 type 2 light
AC100
~242
68.4
10,550
154
5,000
85.0
60,000
*LED base light GB-1 series is a product of Sanken Electric Co., Ltd.

Compliant standards / precautions

Compliant standard

Precautions when installing LEDs

  1. Do not connect to a three-phase power supply.
  2. In factories with large inductive loads, it is recommended to install a noise filter with a power supply to prevent malfunction of the LED straight tube.
  3. Power consumption varies slightly depending on the usage environment. In addition, there are some variations in brightness and light color of LED elements.
  4. Expected life means the expected life in an environment with an average ambient temperature of 30 ° C.
  5. Specifications are subject to change without notice due to improvements. Please note.
  6. In addition to the products listed in this catalog, we also handle various LED lighting fixtures. Please contact the person in charge for details.

Precautions when connecting to existing fluorescent lighting fixtures

  • For glow type, be sure to remove the glow before use.
  • Existing appliances have a built-in ballast to facilitate the start-up of fluorescent tubes.
  • Ballasts have a limited lifespan, and generally, those that have been used for 30,000 hours or more may deteriorate in performance due to deterioration.
  • Since the ballast itself consumes power, and an old ballast may catch fire, disconnect the ballast circuit before use.
  • Refer to the figure below for disconnecting the ballast circuit.
○ ── ○ ・ ・ ・ Wiring connection work × ・ ・ ・ New line construction
Note) Power to the LED lamp is supplied from both ends of the socket.

LED lighting straight tube lamp, base light general catalog download

LED lighting installation example

2022/6
Sun
Mon
Tue
Wed
Thu
Fri
Sat
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
Clean Venture 21 Corporation

612-8445
Kyoto City, Fushimi-ku, Takeda Jobodaiin-cho 41

TEL. 075-612-2100
FAX: 075-612-2177
Back to TOP